View Single Post
  #11  
Old 15-09-2013, 01:16 PM
stevieturbo stevieturbo is offline
Senior Member
 
Join Date: Nov 2005
Location: Northern Ireland
Posts: 80
Default Re: injecting hot side

If you are only using pump fuel and because of this are severely knock limited, then I would just go with the typical WI setup and inject between the IC and intake valves.

I only posted the question to deal with charge air temperatures only. Nothing as to what might happen in the chamber, which is a key aim of a more typical WI installation.

Good info there though. Even at 40psi boost, water would still boil off at 130degC. So water should remove a fair chunk of heat if injected hot side.
Reply With Quote