[Richard L]

My replies in Green.

You wrote:

this test fails
2. Simulating 100% injection test:
Remove the link and put it on the “TST” slot momentarily
and observe:
- Amber led on the controller board will light up.
- Red led on the controller board also lights up.
- The yellow should light up except for the blue RJ
connector,which lights Yellow light on the red harness should light up
- The water pump will start. doesnt start the blue wire on the blue connector should be grounded by the controller.Check the pins of the blue RJ connector
- There should be full spray on the jet instantly
unless the system is not fully primed. Allow a few
seconds for the water to reach the jet. For longer
hose run installations, remove the jet first to allow
faster priming.
- Remove the link and put it back to the “PRK”
position before you empty the water tank. If all is
well, move to the next test stage.