Thread: can water injection effectively replace over-rich a/f ratio
View Single Post
  #2  
Old 30-10-2003, 02:11 AM
RICE RACING RICE RACING is offline
Senior Member
  
Join Date: Oct 2003
Location: Utopia
Posts: 511
Default
I have run WI at an AFR of 10.8:1, basically at a rate of %14 to fuel flow. Operation was fine @ power level of 472 rwhp.

I use a very strong CDI ingintion set up which I found mandatory when using WI at this AFR.

I have used AFR's of around 13.7:1 !!! with 20psi boost pressure on normal 98 octane (RON rating) again with WI at a simlar flow rate percentage to fuel flow.

All good results
Reply With Quote