Quote:
Originally Posted by Hic
Mixja
you can use anlaog input 1 for 0-5V flow sensor. Then use this for an axis for fuel/ignition trim. It works like a dream!! Also, for HSV you must use 2 injector outputs, because it is 13ohm.
Richard, you can drive HSV and make a 3d map depending on boost/rpm/ex backpresurre/EGT/etc etc etc....
|
Are use using the close loop control for the time being?
It is possible to integrate all those inputs but how does one work out the unteraction between them, such as priortising them etc.
Richard