[Rohpatem]

Ok so I tried below with 4mm removed after fav.
Hf3 board made a clicking sound then lights on Gauge water level, water injection came on yellow no spray after multiple blips.
Also tried moving fav jumper to sys and no spray
" Activate the system by F-IDC:
a. Set the far left trimmer to fully counter-clockwise.
Crank the engine and leave it to idle, you should see
the blinking green led on the controller board.
b. Blip the accelerator paddle sharply to induce an
artificial load. The amber led should respond. A faint
but noticeable spray should develop at the jet."