Thread
:
2011 Mazdaspeed 3 | HFS-4 Install
View Single Post
#
2
13-08-2013, 04:12 PM
skeurton
Junior Member
Join Date: Apr 2012
Location: Hampton, VA
Posts: 11
Re: 2011 Mazdaspeed 3 | HFS-4 Install
I used Posi-Lock wire taps to connect to the ECU. Cleaned it up a bit with electrical tape and wire loom.
I had two bungs welded into one of the IC cold pipes, just in case I might need to run two nozzles at some point.
Here you can see how the wires and tubing were routed into the engine bay from behind the glovebox. Again, I used wire looms to keep it looking tidy.
The FAV is mounted on the driver side frame rail, just above the nozzle on the IC pipe.
And finally, I secured 10 gallons of VP M1 for $74.
Last edited by skeurton; 13-08-2013 at
09:02 PM
.
skeurton
View Public Profile
Send a private message to skeurton
Find all posts by skeurton