Quote:
|
Originally Posted by Richard L
Perhaps I did not explain very clearly... try again.
Water level snesor: the gauge led will showe every flicker when the level sensor is activated, but will not trigger the failsafe until it is triggered persistently.
FCM: I am sending you another module to see if the original one has trapped debris or partically clogged or something jammed into the flow sensor turbine.
|
Thanks Richard.
I understood that there is "low pass filtering" on the water level trigger. It was strange that it went off at all when the tank was full. I didn't understand the bit about "matching specifications for this batch...."
I adjusted the WL pot a bit yesterday as well as lowering the IDC threshold some more. I didn't get the Water level LED but the flow meter is still in-consistent, sometimes stable at ~5bars and sometimes bouncing up and down several bars, peaking at 6/7 bars.
Also pm's you my address.