Quote:
Originally Posted by Rene Barfred
Hello WI freinds
1. Where is the best place to install the injector noozle ?
2. Should I use 1 or 2 ? (I think I can adjust the flow of the injectors from the controller)
3. I plan to use the washer tank, is it big enough and where would a good place for the pump be ?
4. If better use a trunk tank, any suggestions (pic's/installations)
5. Where to place the controller module/flow module/DDS3 gauge and how to run the wiring ?
|
possible answers to your questions:
1. Where possible, place the jet as far away from the throttle as possible. This allows more tiome for the water/methanol to evaporate. During this process, heat in being absorbed. As the drop evaporates, the droplet size reduces. Smaller droplet promotes better cyclinder distribution.
2. The HFS-6 is designed for trunk mounted. No reson whereit can be placed in the engine bay. But there is a risk for exposing the pump to the elements. Although the pump is zinc plated, but it is a sacrificial coating.
3. The tank and pump should alway be close to each other.
4. --
5. Th econtroller should be place inside the car or grove compartment. This give instant access to user. Allow adequate length to ease inspection.