Re: problems with FAV solenoid - no work, but getting very hot!
This is good, no wiring problem there.
Please check the voltage of the following test points (against controller ground):
(with the ignition on, engine not running)
1. test point 5 injector(+)
2. test point 8 injector(-)
3. test point 23 injector(+12)
4. test point 1 FAV drive (check resistance. not voltage)
5. test point 16 (IDC%)
6. test point 15 internal 5V reference 1
7. test point 11 internal reference 2
8. test point 30 internal reference 3
That is all for the time being.
I would also like to have a good picture (well focused) of the controller circuit board (top side and bottom side). Like to see the settings and configurations.
__________________
Richard L
aquamist technical support
|