[Caspergti]

All done, and it is now working how it should be apart from one thing.

I have run out of trim on the SC pot on the gauge, at full power (currently trying to set it up using the "sys" and "inj" jumpers in for full flow) i can only get 4-5 bars with the gauge pot turned fully clockwise.

When the pump is activated (spool up) i see 7-8 bars which then drops to a constant 4-5 bars, this is after about 4-5 seconds at full flow. I am currently using a 0.6mm jet.

Is there any way for me to get the constant flow reading up a little bit? Or will i have to adjust the WH and WL trim pots to suit that?

John