[BlwnAway]

Yes, sorry for that, FDC Jumper Test.

I didn't find instructions for the FDC test, so just preformed the test as such:
Linked the FDC test pins,
Did a hard pull in 3rd gear, with multiple IDC pre-scaler configurations, then choose the configuration where the bar graph display best mimicked the actual IDC from my datalogs, which ended up being x1.00.

As far as having a bar graph display during any actual flow tests.
No.
There was no visible bar graph during the SYS Test linking, with the threshold trimmer fully Counter Clockwise, (the LED's on the board did operate correctly with throttle)
Or during the drive test with the external jet (still with the threshold trimmer fully Counter Clockwise) even though the actual flow rate change with RPM is evident.

The only time the bar graph display seems to work is during the FDC test and SC calibration adjustment, but nothing on any flow testing.