Quote:
Originally Posted by sainz911
Hi, I'm in Italy, scuse me for my English.
I have buy a aquamist system 2d, and I want install this on my mini coper s 2005.
I have see the beautifull installation here in this forum, but I have any question:
In the aquamist box I have 3 jet, 0.7-0.8-0.9
What jet I can install? and at what pressure? (I want use 50% water 50% methanol)
And the pressure sensor where can I install? next jet is good?
last question, what is the difference if I connect the two wire (red and green) at the fuel injector o if I connect the red wire at 12v switched?
tanks
|
Sorry for the delay.
I think a 0.7mm jet will be good. I thinh the system shoudl come on at about 5 psi. (factory set to 10psi). I would insrtall the pressure (with rem,ote hose) to any where after the intercooler.
It is better to connect the red wire to fuerl injector (+). Or ignition switch position 2 (pre-cranking). Never at the accessories 12V supply.
I guess you have seen this installation?
http://www.aquamist.co.uk/phpBB2/viewtopic.php?t=1166