Re: 3SGTE wiring failsafes
ok this is my plan:
4 way connector:
red - fused - switched positive (red lights ignition)
black - ground
white - ground
purple - lights
all at fuse box in engine bay.
ECU Grey RJ48 Connector:
red - to IGT (Igniter) switched positive (red lights ignition)
green - to #1 (Injector) pulsed ground (hopefully, will check with multimeter)
blue - to PIM (Map sensor) 0-5v signal wire.
these wires are just joined 'Y'
failsafe:
cut TPS wire (turbocharging pressure VSV):
white - to ECU side
brown - VSV side
all these directly from ECU. mounting HSF ECU alongside
i am hoping for 300 - 310 RWHP when i get dynoed.
i am using a single 0.7 jet after the intercooler. i need to solder link 1 & 2 in the flow map table.
|