View Single Post
  #11  
Old 30-12-2015, 05:30 AM
jondee86 jondee86 is offline
Member
 
Join Date: Dec 2015
Location: New Zealand
Posts: 78
Question Re: JET PLACEMENT FOR AIR FLOW (POST-MAF)

I have been struggling to find a good layout for the discharge ducting for
some time. One of the options would be to make an entry to the plenum
from below as you suggest. I will be using this discharge manifold...



In the available space I would only have room for a single short radius
90deg bend, and without any length after the bend for the airflow to settle,
I think that distribution into the runners would be unbalanced. I have been
wondering if some kind of "splitter" inserted down into the discharge end of
the duct could be used to help balance the airflow betrween 1+2 and 3+4 ?
The splitter could be attached to the blanking plate used to close off the
existing opening on the top of the manifold.

On the plus side the charger discharge manifold has a machined face that
looks to be suitable for mounting a single misting nozzle.

Cheers... jondee86
Reply With Quote