[Richard L]

Not sure how your method of measuring flow but will accept your posted flow rate of 650cc/min. Potentially you can remove up to ~30KW of heat if the water is fully evaporated.

I same Jeff's oscilloscope trace of read on more than 0.06V of noise (includes back ground noise). I think your public comment on one of the forum stating the aquamist flow sensor has a oscillating signal of 0.2v to 0.8V. that is 0.6V is unfounded. I would be grateful if you can make a post to correct this finding.

All good logging device should have some sort of high-pass, low-pass or band pass filter. I guess the BMS logging software does not have this facility. This is what I meant before as unreliable.