Quote:
Originally Posted by Richard L
Please give me the following answers:
1. Which version is the HFS3?
2. serial number.
3. What wiring diagram are you using?
4. Is this a new install
5. Is the water level sensor installed in the correct orientation? Does the lever points upwards 45 degrees when tank is full?
|
Hi Richard,
1- V3
2- sn: 102169
3- view attachment
4- yes this is a new install
5- yes it is, while on the matter, the reccomended 22-23mm hole in the manual will not work and the rubber gromet will pull through, a 16-17mm hole will allow the gromet to compress properly into an oring to seal.