Re: HFS-3 not spraying ::mystery solved::
Bringing this to back because I have still/again a flow issue. After I adjusted the threshold to start flow at lower IDC I saw 7-8 bars in in gauge. Only a short after I was seen only 5-6 bars and the yellow "water level" -light lights up when the system start spraying which indicate the fail safe been activated.?
Water level is not low so what could cause the failsafe to activate? Flow sensor, faulty FAV? What things shoud I check first?
Another question about WL and WH potentiometer: No matter where I turn these I see the red "B" lighing up when starting to get boost and on boost. When the system is adjusted correctly should the "B" light up?
|