Yellow Gauge led during WOT
Have a question I am hoping someone can answer. I purged my system and refilled my tank and now having an issue and trying to narrow it down.
My 0.9 jet broke when trying to put it back in due to corrosion from the system sitting for 6 months over winter so I removed the brass inner and put it in another jet sleeve.
Things were good for a few WOT pulls and now getting boost cut and it is obvious boost is outside the fail safe range. I am assuming that either the jet or something is plugged by debris and not getting the right amount of water pressure or the swapping of the brass inner has made the flow incorrect compared to the original.
Q- If I do a flow test at 100% will the gauge display if I am outside the fail safe parameters with the yellow led?
Q- Is there a way to determine if pressure is above or below the fail safe settings?
Thanks
Mark
|