Quote:
Originally Posted by Puddin15
I think I found the answer to my own question. Looks like page 20 (in the manual) shows the correct wire layout for DI applications which uses the yellow cable.
I did have a few questions on the jumper and solder settings though.
For the jumper settings, I believe all of the settings should be set to the default setting except the SET FAIL SAFE. I will be using an external trigger with a 5-12V input, so I believe this jumper should be set to FS1. Both CLP and FS0 jumpers can be removed. I will use the orange wire on the RJ48 connector and splice it with the external trigger of the boost control device.
For the solder settings, I plan to use the following settings:
AUX INPUT: default
IDC PRE-SCALER: x2.5 for DI
MAP SENSOR TYPE: 2.5 bar MAP sensor so I believe I need to solder link 2
FLOW SENSOR MAP: I'm using a single 0.9mm jet so I need to solder pads 1 & 2
AUX INPUT SELECT: default
AUX INPUT FAILSAFE: I believe this should be W?
Are these settings correct?
|
All the settings are perfect. Not sure about the last question.