Re: Mazdaspeed 3
I think I'm confusing myself here. The AUX INPUT FAILSAFE is if I'm connecting a 3rd party signal to activate the onboard failsafe relay. I'm not using a 3rd party signal so I can keep this as the default setting.
I was under the impression that soldering the W setting would allow the water level sensor to cause a failsafe. Sorry for the mixup.
One last question for you, is there an indicator on the gauge if the control loses power? Reason I ask is I will be using the MAP Switching Channel for the fail-safe and not the Change-Over relay.
Last edited by Puddin15; 20-08-2016 at 08:38 PM.
|