Re: HFS-3 not spraying
I did spray test as said in the manual:
2. Priming and purging of the system:
a. Fill up the tank with water half way.
b. Disconnect the 6mm hose from the FAV assembly
and put the hose into a container securely.
c. Ignition switch in pre-crank position and gauge is
switched on. Uncover the controller and pull out the
?Inj? jumper (disabling the FAV) and put it to the link
marked ?SYS?. The pump should power up and
water should come out of the 6mm hose within a
few seconds, Let it run for a 10-20 seconds so that
trapped air and debris are purged.
Although my problem also is my gauge won?t light up when I turn the ignition on. It only lights up 15s after I?ve started the car. I did send email to Rickhard about this but I think he?s still out of office.
|