Quote:
Originally Posted by Richard L
Please check each plug for the corrtect wire orders. Correct the order meanwhile by cut and splice. Let me know your address and I will replace the harness accordingly. It is possible that one or two of the harness were mixed up from other systems. Email me [richard@aquamist.co.uk] and I will send them when I return to my office on the 9th. |
Quote:
Originally Posted by Richard L
The correct wire colour order of the grey harness should be... from gauge side
-(red) 2011-May on version
-red
-green
-orange
-white
-yellow
-blue
-black
-Silver brown
-(brown) 2011-May on version
Dispose the incorrect harness asap |
Richard, did you get back yet and did you get the emails I sent you?
About those two different ECU harness is the first one
"V1" and the second
"V2"? I was reading this forum and came across that the V1 version has blue board and "INJ" and V2 has black board and INJ is replaced by "FAV". Is this correct?
If it is my controller has V2 black board (and there is DFS jumper) but my gray ECU harness look the same as in the first picture.