[Richard L]

EvoTio,

Thanks for posting the pictues to the forum, very neat installation. It must have taken you a great deal of time to put it all together.

I have noticed one little improvement you can do- the flow sensor is mounted horizontally (cable direction) rather vertically. Thereis a small chance some water may find its way into the sensor and eveentually causing problems. Other than that, everything is perfect.

Depending on your usage, track racing might shorten the life of the priming pump since theyare not continuous rated, it you can put an inline resistor or 1 ohm or so so cut down the current drawn. The resistor should be 25-50W wire wound type and shoudl be bolted down to a materal surface for heat dissipation. Alternatively, use two pumps in series.