View Single Post
  #8  
Old 02-06-2018, 11:16 PM
rallyfreak202 rallyfreak202 is offline
Junior Member
 
Join Date: May 2018
Location: United States
Posts: 4
Default Re: New install issues

Quote:
Originally Posted by Richard L View Post
If the wires are swapped incorrectly, The controller will click as well as the green led. If the connections are correct, only the green led blinks, no clicks on the controller.
I verified the green wire is going to ground side of injector and red is going to positive. I did notice that the negative side of injector (green on Aquamist) would show 14v when keyed on with injector unplugged and only the ECU harness connector plugged into controller. My other injectors will show voltage on negative side when ignition cycled and injector plugged in (no voltage on net side when unplugged and ignition cycled). I’m guessing this is normal.

Now what do I test?



Quote:
Originally Posted by Richard L View Post
Also can you tell me the serial number of the controller.
103055
Reply With Quote