View Single Post
  #1  
Old 21-04-2017, 03:46 PM
Arthurwiljami Arthurwiljami is offline
Member
 
Join Date: Oct 2011
Location: Finland
Posts: 36
Default Flow sensor testing

When doing a spray test should the bargraph lit up any leds during testing?
How well the flow sensor should flow when blowing air throuh it with my mouth? It is farely hard to blow but I do feel fibration and hear the sensor rotating. Is that OK? During flow test both jets are spraying fine so the system does flow.

Problem is I get failsafe on boost and can't get any leds lighting up in the gauge bargraph. I've tested different setups with onboard trimmer, thres, gain etc. and was wondering if the flow sensor is bad or not.

Last edited by Arthurwiljami; 21-04-2017 at 03:55 PM.
Reply With Quote