Quote:
Originally Posted by Richard L
This may not work well. The flow sensor signal sensitivity is controlled by the gauge via the HFS6 controller. If you take away the HFS6, the flow sensor will not function properly.
Does the motec have a D to A output (0-5V) to control the flow's sensor sensitivity?
|
If I understand this correctly, a 0-5 volt signal is used by the FCM to scale the output of the flow sensor. So if I input a regulated (Constant) 5 volts from the ECU, I'm assuming the full flow capability of the sensor would be metered in a linear 0 - 5 volt range?
If this is correct, what is the resolution of the 0 - 5 volt range? 255 points?