View Single Post
  #2  
Old 13-08-2013, 04:12 PM
skeurton skeurton is offline
Junior Member
 
Join Date: Apr 2012
Location: Hampton, VA
Posts: 11
Default Re: 2011 Mazdaspeed 3 | HFS-4 Install

I used Posi-Lock wire taps to connect to the ECU. Cleaned it up a bit with electrical tape and wire loom.






I had two bungs welded into one of the IC cold pipes, just in case I might need to run two nozzles at some point.






Here you can see how the wires and tubing were routed into the engine bay from behind the glovebox. Again, I used wire looms to keep it looking tidy.










The FAV is mounted on the driver side frame rail, just above the nozzle on the IC pipe.






And finally, I secured 10 gallons of VP M1 for $74.


Last edited by skeurton; 13-08-2013 at 09:02 PM.
Reply With Quote