View Single Post
  #17  
Old 20-11-2017, 08:14 PM
trdhilux trdhilux is offline
Junior Member
 
Join Date: Jun 2015
Location: NSW, Australia
Posts: 16
Default Re: HFS-6 Inconcistent Injection

Haven’t done a times flow test yet, will do that soon and report back. Will be with the 0.8mm jet as I recently changed down to that.

Yes always use distilled water, I will go over the pump and see if there is any corrosion. When I have put into TST before, the flow seemed to be solid with no variance in flow for the whole test period, this was for quite a few minutes as I ran nearly two liters through it. How does the flow sensor work? Is it an external sensor? I can only see cabling going to the circuit board, nothing going to flow sensor, or is it a paddle wheel and Hall effect type arrangement?

Will report back soon.

Josh
Reply With Quote