[trdhilux]

Bit of an update of some work i have done.

I tested the cc/min of the installed #8 jet. It only pumped out about 260cc. The chart shows at 160psi should be near 460cc/min. This is indicating to me the pump could be failing.

I pulled the flow sensor housing apart and everything was free, blowing through the unit with my mouth i could feel the trigger impeller spinning. This is telling me the it either isnt spinning due to reduced pressure or flow in the line.

Next step will be to pull apart the pump head and check for signs of corrosion etc.

Other than that, i can only assume that the flow sensing circuit has failed.

Josh