Hello,
I just got hand on a HFS3 V2KC board which was installed on a Mitsu L200 turbo diesel.
This PCB has gone thru few changes.
I would like to set it up back to factory setting (it is going on an evo3 now)
anyone would have a picture of same PCB with default setting ?
Or could you tell me what are the default settings ?
I'm pretty sure the MPS soldering has to be removed, then solder bridge IDC again (I think this has been cut)
now what about CUST, PWM-, PWM+
Then *1, *1.5, *2
thanks