Hi, Richard.
HFS-6 is new, everything is just from the box, everything was sealed. Just purchased it from ebay. Can send you details and seller contact info of the seller if necessary.
Checked the connector - it is fine. Pushed the pins additionaly - didn't help. Same thing.
Ground (dunno what else to check with the module):
Module itself:
(Used black water line from previously installed AEM unit)
box with serial on it:
Here is the video. Probably this will help to understand the situation:
http://www.youtube.com/watch?v=5jrMO677InI
Notice the "S" lamp being lit and not while plugging and unplugging the connector. Also, as I've said, there is some relay-like "click" on FCM.
I thought that maybe lamp on the socket is not working (what else to thing about?
) - but during test run on full boost there was no flow.
I've also made a video with 100% flow simulation, but picture is similar. All the lights on controller are lit, but no flow.
Please, any suggestions, is it FCM or main unit itself? Where to dig? Now I'm feeling quite disappointed after spending almost 1k usd and two days for installation and having not working unit after all, instead of AEM which was working fine...