HFS-3 / Failsafe / Map Switching Output
I have been using your System in the Hydramist version. (DDS v8)
I will be interfacing the HFS-3 with a HydraEMS in a Honda S2000 application
I want to use the HydraEMS auxiliary map feature so I would like to know which output from the HFS-3 is equivalent to the MAP-SW2 output from the DDS-v8
This output enables the ECU to use the auxiliary fuel-trim map and allows to run with or without the Water Inj. system on. - I could wire an "external" switch but if it's already available from the DDS3 display gauge then I would like to wire it that way- similar to the Hydramist.
Also which output from the HFS-3 box can be used for a solenoid boost-cut relay when a fault is sensed? This could be a (+) or (-) trigger?
thanks!
|