[Canonshooter]

Yes, I just recently did so myself! The system can handle up to 1500 CC of flow.

I am using a single .8mm jet/360 CC in the outlet of my top-mount intercooler (Subaru). I added a second .3mm jet/65 CC connected into the OUTLET line of the FAV to spray the top of the IC. I had to reset my high/low failsafe window but other than that, the system continues to work perfectly, just as it has for the last 4 years since I installed it.

It was a worthy addition - the 50/50 mix gets "misted" onto the IC and evaporates rapidly. The "butt dyno" indicates improvement at higher speeds when there is plenty of air flow through the IC, enabling additional cooling from the evaporating boost juice.

A few photos of my install;