View Single Post
  #13  
Old 02-05-2018, 01:09 PM
trmurphy21 trmurphy21 is offline
Junior Member
 
Join Date: Nov 2017
Location: Dublin
Posts: 15
Default Re: Problems with set up

will do thanks. i have checked these i'll double check again. made the mistake of using a phase tester instead of a multimeter on the green injector wire and engine spluttered a bit (opened injector fully) and getting between 2-4 volts on the blue map sensor (will confirm)

also just to check, what readings should i be getting on the 2 signal points on the pump relay with the sys jumper in and out? meter points: black to earth in boot , red to 2 points or meter points: black to blue , red to red?

cheers
Reply With Quote