[Arthurwiljami]

What I ment to say about flow bars I don't see 7-8 bars at any stage. I thought the flow was reduced so it only show 5-6 bars for some reason and therefore failsafe is activated?? But I'll check this out when the weather allow to me to test this on the road (snowy roads).

If you see 7-8 bar at the gauge, it will trigger the failslafe because it has exceeded the upper limit of the flow window. (WL).

So do I need to adjust SC to counterclockwise a little so it doesn't go up to 7-8 bars?

1. Increase the failsafe delay on the controller (clockwise)
2. Shorten the hose length between the FAV and jet
3. Create a downward hose loop between the FAV and jst so that gravity will help keeping the water inside the hose.

1. I'll increase delay if needed.
2. hoses are almost as short as they can be.
3. Will try to make the loop. The jets are now lower than FAV.