View Single Post
  #9  
Old 25-12-2015, 01:19 AM
jondee86 jondee86 is offline
Member
 
Join Date: Dec 2015
Location: New Zealand
Posts: 78
Smile Re: JET PLACEMENT FOR AIR FLOW (POST-MAF)

This picture shows the angle of the intake connection on the 4AGZE...



That intake usually connects to the intercooler outlet (the intercooler is
mounted on top of the cam covers). In my case I am installing in a RWD car
and the intake connection will be coming up from the charger mounted below
the manifold. I do not have enough clearance between the top of the engine
and the hood to go up high and then connect to the OEM intake pipe. So I
will have to fabricate an intake connection that comes from below and then
makes 2 x 90 degree bends to connect to the intake manifold.

Whatever I do it will mess with the factory airflow that probably was set up
to give reasonable distribution to all cylinders. I may well have to insert some
turning vanes or splitters, but that will have to wait until I have the charger
mounted to the engine, and can see how much room I have to work with
when fabricating the ducting.

Cheers... jondee86
Reply With Quote