Re: No flow reading from water injection!
Richard,
I tested the yellow harness wire with a cheap multimeter on the connector pins (harness unpluged from the controller)...here are the results :
Black+ and Blue- = about 1 Ohm
Blue+ and Black- = about 1 Ohm
Black+ and Red- = about 30 Ohm
Red+ and Black- = about 300 Ohm
Blue+ and Red- = about 30 Ohm
Red+ and Blue- = about 500 Ohm
Yellow+ and Black- = about 4 Ohm
Does this make any sense to you!?
Could I plug my old HFS-3 controller and make the windshield spray test to see if the bars on the gauge illuminate?
Last edited by torquemaniac; 08-09-2015 at 01:05 AM.
|