#1
|
|||
|
|||
need to know injector info....
Ok i am going to install a direct port injection system to my manifold but i need to know if a 1/4 hose size will fit on the aquamist injectors...reason being is i already have another brand pump and hoses that i would like to use for water injection but i would like to use the aquamist injectors for it. Does anyone know if it will fit? Also does anyone know a good place onlime to purchase the aquamist kit and parts? Thanks
|
#2
|
|||
|
|||
can anyone please help?
|
#3
|
|||
|
|||
Mate, I jast got some nozzles and they are 4mm. I belive there are also 6mm tails available. It's all listed here:
http://www.aquamist.co.uk/sl/plist/frm-4-USD.html There is also list of distributers you can call. This is all I can do for you. This forum is really informative but takes ages for a new person get helpfull answers as most piople here only visit this place few times a week. |
#4
|
|||
|
|||
Go to the Aquamist website then click supplier listing. Click USA or Non-USA. Look on the right side to see the resellers...I copied the links to each below to save you the time.
USA http://www.aquamist.co.uk/sl/plist/frm-4-USD.html NON-USA http://www.aquamist.co.uk/sl/plist/frm-4.html Contact the reseller directly and explain what you are wanting to do. They will be able to get you the parts you need. I have not heard a bad thing about any of them so you should be OK picking one on your own. . Also, stick with the 4mm or 6mm line that is intended for the Aquamist jets, US or SAE do fit but it's a pain to get them on properly. If you are using a surflow pump based kit you need to get 2 x 3.8 to 1/8 BSP adapters so you can switch to the Aquamist fittings. Attached image should help.....I got it from another thread on this forum but can't remember the specific thread |
|
|