#1
|
|||
|
|||
Pump Wiring Harness / Level Sensor 2 pin Connector
Hello, just found out that the level sensor 2 pin connector is missing from the used HSF4 kit i bought, can anyone point me where i can source the 2 pin connector that is currently on the kit?? otherwise i will repair with a standard connector it but will have to cut and change the level sensor cable end as well.
IMG_0851.JPG By the way, i'll be installing in a 996 IMG_0850.JPG |
#2
|
|||
|
|||
Re: Pump Wiring Harness / Level Sensor 2 pin Connector
The connector is made by tyco or amp. You can use any pair of mating connectors for this
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: Pump Wiring Harness / Level Sensor 2 pin Connector
Hey Richard! thanks for the Info.. i ended up using a Molex Male / Female connector plus added a little bit more or cable. Continuity checked on all cables and everything in good shape now!
some pics IMG_0853.JPG IMG_0854.JPG |
#4
|
|||
|
|||
Re: Pump Wiring Harness / Level Sensor 2 pin Connector
Thank for the update... All good.
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
Re: Pump Wiring Harness / Level Sensor 2 pin Connector
Richard, can you tell me the dimensions of all the orings used in the system? Also the one that goes on the right angle fitting as well!
Last edited by Gclasse; 09-06-2017 at 03:48 AM. |
#6
|
|||
|
|||
Re: Pump Wiring Harness / Level Sensor 2 pin Connector
I don't know the size of the o-ring on the right-angle fitting as we don't make them.
There are many o-rings on the system , be a bit more specific.
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
Re: Pump Wiring Harness / Level Sensor 2 pin Connector
Don't worry Richard, Jeff (Howerton engineering) sent me some spare orings on different sizes. All good now!
|
#8
|
|||
|
|||
another question on my install
Richard, on my setup (porsche), i decided to install the nozzles at both intercoolers sides. Therefore, I placed the FAV close to driver side intercooler and from there I ran the 4mm tubing to a check valve which was then distributed to each intercooler. Refer to pictures included.
On your experience, Is there a concern with the total length of the 4mm used on this setup? Last edited by Gclasse; 13-06-2017 at 04:19 AM. |
#9
|
|||
|
|||
Re: Pump Wiring Harness / Level Sensor 2 pin Connector
I suggest putting an inline checkvalve near the far-away jet to stop water siphoning after lift off.
__________________
Richard L aquamist technical support |
#10
|
|||
|
|||
Re: Pump Wiring Harness / Level Sensor 2 pin Connector
Got it, ordered one from your website today! thanks
|
|
|