#1
|
|||
|
|||
AUDI specific wiring diagrams...
__________________
Richard L aquamist technical support |
#2
|
|||
|
|||
Re: AUDI specific wiring diagrams...
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: AUDI specific wiring diagrams...
thanks a bunch!!
|
#4
|
|||
|
|||
Re: AUDI specific wiring diagrams...
Richard I ll be glad if you add 2008 s3 2.0 t fsi wiring diagram too.
|
#5
|
|||
|
|||
Re: AUDI specific wiring diagrams...
I did a little research, audi S3 turbo has many many engine codes:
1.2 TFSI (2010 on ) ........... CBZB 1.4 TFSI (2007 on) ........ CAXC 1.8 TFSI (2007 - 2008) ....... BYT/BZB 1.8 TFSI (2009 on) ......... CDAA 2.0 TFSI (2004-2008) ......... AXX/BPY/BWA/CAWB 2.0 TFSI (2009 on) ............. CCZA 2.0 TFSI (2006 on) S3 only ................. BHZ/CDLA 2.5 TFSI (2011 on) RS3 only ................ CEPA Which one is yours?
__________________
Richard L aquamist technical support |
#6
|
|||
|
|||
Re: AUDI specific wiring diagrams...
BZC001301 is written on engine bay.
So which one is the proper one I can't figure out. Do you have any idea? |
#7
|
|||
|
|||
Re: AUDI specific wiring diagrams...
I working on them. Only recently I realised how many variations are there. Luckily the engine mangements stay pretty constant.
It is just as simple easy to splice it at the fuel injector rather at the ECM. I would welcome anyone who can submit any useful ECM pin out to help.
__________________
Richard L aquamist technical support |
#8
|
|||
|
|||
Re: AUDI specific wiring diagrams...
Hi Richard, I'm going to install the HFS-3 on an audi s2 ABY, and my question is if you know what wire I need to cut to install the fail safe, boost cut, and what wire is the inj#1
I think the signal inj#1 that I need, It's pin 36, is it right? For the boost I have a external MAP sensor, because don't want to weld one wire on ecu, do I need to cut the boost signal wire and intercalate white and brown wire after blue wire?? I attach you a little scheme of the injection http://www.s2central.net/S2_Schematics/B/B73-04.pdf Thanks! |
#9
|
|||
|
|||
Re: AUDI specific wiring diagrams...
I was thinking about the fail safe and what I wrote was bad...I think that I need to cut and intercalate the aquamist wires between N75 wire, pin 33, because It's what control the boost, open and close the wastegate
http://www.s2central.net/S2_Schematics/B/B73-05.pdf the boost and injector signal I think it's good |
#10
|
|||
|
|||
Re: AUDI specific wiring diagrams...
Yes, you are 100% correct.
White wire to pin33 and brown wire to N75
__________________
Richard L aquamist technical support |
|
|