#1
|
|||
|
|||
flow sensor
hello there , i did not switch the HFS3 since 6 months , so now i going to switch the methanol injection ON , but am afraid that the flow sensor has been damaged or dirty , so how i can clean the sensor ??is there a instructions for that ??
do the pump failed if i did not run it since long time ? because am running 100% meth and it may allready damaged the seals inside the pump ! so what do you think ?? |
#2
|
|||
|
|||
Re: flow sensor
Do the following:
1. Disconnect the 6mm hose from the FAV and purge the system through properly. 2. Reconnect the 6mm hose 3. remove the water jet/jets and clip it/them to the windshield. 4. Manually activing the system again. 5. Observe the spray has a nice cone. 6. Observe the gauge and let me know if you see any bars display on the gauge.
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: flow sensor
richard , i just got the car from the workshop and found this ..
the mechanic guy forgot to zip tie the FAST ACTING VALVE , so it touched the crank pulley and damage the wiring as you see in the pic , as well as flow sensor plastic piece i still did not test the system , so should i buy the wiring ??? |
#4
|
|||
|
|||
Re: flow sensor
I wouldn't recommend plugging in the damaged harness into the controller, may cause more damages.
Contact me at richard AT aquamist.co.uk
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
Re: flow sensor
email sent sir
thanks |
|
|