![]() |
#1
|
|||
|
|||
![]()
BMW M6/F12
My car used to be running on JB4 and the aquamist was working like a charm. I have recently moved from JB4 to BCM and since then the aquamist is not working at all. Have anyone else had the same issue, if so please share any solution. |
#2
|
|||
|
|||
![]()
Who is BCM?
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
![]()
Boost Control Modual
|
#4
|
|||
|
|||
![]()
BCM this is Boost control modual for burger motor sports..
|
#5
|
|||
|
|||
![]()
Can you send a link to BCM?
__________________
Richard L aquamist technical support |
#6
|
|||
|
|||
![]() |
#7
|
|||
|
|||
![]()
When you say it is not working, does it mean...
( I did some reading from your link) 1. The aquamist is not spray 2. You are not getting extra boost from the JB4/S2 with BCM 3. Does the latest S2/BCM module support meth at all?
__________________
Richard L aquamist technical support |
#8
|
|||
|
|||
![]()
Please post a hi-res picture of the controller board, I like to take a look of the settings.
__________________
Richard L aquamist technical support |
#9
|
|||
|
|||
![]()
The HFS4 reads the fuel duty cycle, it should not be affect by the BCM. All it does is to manipulate the boost signal into the ECU. Nowhere near the fuel duty.
It can work independently.
__________________
Richard L aquamist technical support |
![]() |
|
|