![]() |
|
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I’ve been using HFS3 for a couple years and it’s been working without
any problems. Then I haven’t used the system for some time. Now when trying to turn the system on, no backlights or flow sensor display switch on, the only light still working is "water level". The controller is connected correctly, there is a fuel injection load indication. When closing with a “sys” jumper, the lamps on the controller switch on and the flow control valve triggers, but the pump still does not turn on. The pump is undamaged, I tested all the connectors and wires, they are also fault-free. A small note. When inserting the flat cable connector of the gauge slowly and carefully, it briefly lights up the backlight and the flow sensor display. When the connector is fully inserted, the only indicator working is "water level". What can I do? Can you help? |
#2
|
|||
|
|||
![]()
1. Check the tank level
2. Unplug the water level sensor and see if the system starts LMK
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
![]()
It did not help.
|
#4
|
|||
|
|||
![]()
Can you post a picture of the controller (with all cable plugged in) and a picture of the gauge.
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
![]() |
#6
|
|||
|
|||
![]()
OK, all is good. Unplug the blue harness and let me what happens.
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
![]() |
#8
|
|||
|
|||
![]()
Weird. I have not seen this before.
Do you have a digital multimeter?
__________________
Richard L aquamist technical support |
#9
|
|||
|
|||
![]()
Yes, of course.
|
#10
|
|||
|
|||
![]()
Unfortunately the pump still does not turn on.
Maybe this video will help? https://yadi.sk/i/cHDzjMmstav78 Last edited by iideaiidea; 24-07-2016 at 10:47 PM. |
![]() |
|
|