#11
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
No but have friend who can or can use local company.
Is it the flow sensor table not being linked causing the issue? |
#12
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
Yes, the flow table must match the jet number. Until you have done the soldering, you can not set the faulsafe (SC, WL and WH) properly.
__________________
Richard L aquamist technical support |
#13
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
Ah!!!! My garage fitting hasnt done it correctly then!
Will get on the case!! Should i also solder the pre amp to 2.5 ? |
#14
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
Why don't you send the controller back to me and I will get it done within the same day. I can also do some calibration for you on the 0.6mm jet.
Richard
__________________
Richard L aquamist technical support |
#15
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
Yeh that would be brilliant Richard thank you so much.
Just send the actual board to you yes, nothing else? Cheers |
#16
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
just the board with the box for protection.
__________________
Richard L aquamist technical support |
#17
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
no worries, all padded up and in padded envelope to be send tomorrow morning recorded delivery signed for.
will you be in office on Tuesday morning or shall send to home address? PM me if home address is better. cheers |
#18
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
I will be in the office on Monday and Tuesday this week.
ERL Ltd Iroko house Bolney Ave Peacehaven East Sussex BN10 8HF
__________________
Richard L aquamist technical support |
#19
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
Perfect, will be with u by 1pm on Tuesday.
|
#20
|
|||
|
|||
Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
Write your return address inside.
__________________
Richard L aquamist technical support |
|
|