#1
|
|||
|
|||
Wiring Failsafe Controller Cut
Hello,
Which wires from the HFS-4 should be connected to the Turbosmart e-Boost2 to cut boost by reverting to the wastegate spring pressure as part of the failsafe? Here is the e-Boost2 wiring diagram: Here are the instructions from the HFS-4 manual: I was reviewing the thread at http://www.bimmerforums.com/forum/sh...r-cut-question but I am wanting specific wiring instructions for this application for clarification. Thank you! Last edited by Schultzey; 29-01-2015 at 05:00 PM. Reason: Corrected Photo |
Tags |
e-boost2, failsafe, hfs-4, wiring |
|
|