New to forum / Custom WI system for AUDI

[simple]

Hello Richard,

Re: test, I can test as per your instructions ? no problem.
However I did not order accumulator with you when ordered goods. As far as I know all what coming is:
1) 3 x 0.3 nozzles (threaded type) 4mm
2) 1 x 0.6 nozzle thereded type 806-309
3) 2 x Filter: 6mm hose. #806-257
4) 2 x Flow valve (not HSV): part number 806-234
5) 2 x Tank fitting: #806-270
6) 2 x HSV (806-244)
7) 4 x Nozzle adaptor with blanking plug 806-357
Please clarify!

I do not use Shurflo pump, instead I run China made (same as Shurflo) copy of Shurflo. Therefore operating parameters as well as results can be slightly different.
I can test 0.3 or 0.6 nozzle for you on my pump with or without accumulator for water delivery and voltage/current ratio when I will receive the goods. Please remember that I feed pump via Switch Mode Power Supply (SMPS) not PWM during my test. However I do not think PWM will perform any different to SMPS (according to my knowledge).

Please explain more detailed meaning of ?cam angle of the pump?.

Your set up as per posted picture of the pump and accumulator look very good as you have accumulator as close to the pump as possible using maximum diameter fitting.