#1
|
|||
|
|||
HFS-6 flow controller wiring
Can someone correct me if I am wrong on the wiring:
Following items are in the Red Harness: 1 red 24awg +12V PSU to Flow control Module 1A max @12v 2 green 24awg Flow Sensor Calibration Signal 5-0 VDC @10mA 5 yellow 24awg Flow Sensor output signal 0-5 VDC @10mA 6 blue 24awg Reserved for internal communication usage Signal level digital 8 brown 24awg PWM valve distribution signal 1A @12V max. Following items are in the stand alone cable: 3 pink 24awg Wastegate By-pass valve option (+12V) 1A max@12v 4 white 24awg Wastegate By-pass valve option (SW-) 1A max to Ground Ground is the singel wire out of the module: 7 black 24awg 0V Ground (signal ground) 1A maximum Thanks! Last edited by bradman77; 15-08-2011 at 03:00 PM. Reason: subscription |
#2
|
|||
|
|||
Re: HFS-6 flow controller wiring
bump, anyone?
|
#3
|
|||
|
|||
Re: HFS-6 flow controller wiring
- Pin1 and pin3 are joined at the FCM module. Your information is accurate.
- The blue wire (post 2010 Dec) is now used to read raw digital signal from the flow sensor. Per-2010 Dec is a return ground to power up the RJ45's green led.
__________________
Richard L aquamist technical support |
|
|