#1
|
|||
|
|||
Jets leaking!
Just finished up my install and ran some tests. Didn't leak during the tests.
Went for a short drive to make sure it was working all good. Got home and opened my engine back to see the very slightest bit of fluid. I'm running 100% meth so I don't want to see anything, ever. Is there a silicone or something like that I can use? or teflon tape of some sort? |
#2
|
|||
|
|||
Re: Jets leaking!
Where is the leak exactly?
When you install the jet adaptors, did you loctite them?
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: Jets leaking!
I didn't loctite them. It's on the Jet adapter to the intake.
I just read that I needed to. haha. So I went out and got some high temp Permatex threadlocker, Permatex high temp thread sealer. Also got some Loctite 242 threadlocker. Now which one do I use? Threadlocker or Thread sealant? Last edited by ek9max; 30-06-2012 at 09:54 PM. |
#4
|
|||
|
|||
Re: Jets leaking!
Anyone of the two will do.
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
Re: Jets leaking!
There are three choices
|
#6
|
|||
|
|||
Re: Jets leaking!
Sorry, I didn't see the second being different from the third
OK, loctite 242 is something I have used before. I don't know enough about the other two to make a sound conclusion.
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
Re: Jets leaking!
We use high temperature loctite for most of our work.
__________________
Richard L aquamist technical support |
|
|