![]() |
#1
|
|||
|
|||
![]()
I hope every one is doing well.
My HFS-3 Installed and adjusted by my tuner on my BT Audi B5 S4, to inject 100% meth. Running +2 bar boost, the HFS3 is not activated until it reaches over 1 bar boost, I would like to make it come on earlier, tried by adjusting the THRES but it is cranked all the way counter clock already by my tuner. Is there any thing else that can be done to make it activate any earlier? TJ |
#2
|
|||
|
|||
![]()
Is your big injector low impedance?
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
![]()
They are high impedance.
Last edited by TJ; 15-11-2012 at 08:56 PM. |
#4
|
|||
|
|||
![]()
Are you triggering the H3 with IDC or MPS?
What are the sizes of your fuel injectors? If they are very large, your duty cycle could be quite small. If this is the case, you can multiply the input by x1.5. Refer the instruction sheet came with the green harness.
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
![]()
Can you measure the voltage on test pin 16 relative to the "ground" pin.
1. pre-crank 2. during cranking 3. engine started and idling 4. light cruise 5. mild acceleration 6. WOT.
__________________
Richard L aquamist technical support |
#6
|
|||
|
|||
![]() Quote:
According to my tuner the system triggers with both IDC and MPS? |
#7
|
|||
|
|||
![]() Quote:
Will look for the instruction sheet but if in case it's lost or missing, can it be found on the net somewhere? |
#8
|
|||
|
|||
![]()
You cannot do that, either IDC or MPS. not boith. Perhaps that is the problem.
__________________
Richard L aquamist technical support |
#9
|
|||
|
|||
![]()
Multiplying does nothing to the failsafe. The instruction sheet is inside the green harness bag.
__________________
Richard L aquamist technical support |
#10
|
|||
|
|||
![]() Quote:
Will check with my tuner if he had actually connected both IDC and MPS. |
![]() |
|
|