![]() |
#1
|
|||
|
|||
![]()
Richard, could you take a look at this ? I saw your post below about adjusting FSDL that didn't help in my case. This has been an issue since I got the unit (about a month ago). Temperature doesn't seem to be a factor here. Does it hot or cold. This doesn't impair the unit, everything works like normal. My concern is when the unit is out of warranty and something goes wrong.
![]() Referencing post http://www.aquamist.co.uk/vbulletin/...ead.php?t=2730 |
#2
|
|||
|
|||
![]()
Not sure what caused this, Can you disable the failsafe (DFS) ans see if it cures it. Also put duct tape on the back on gauge. Condensation may cause this.
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
![]()
Hi Richard, I don't think its a condensation problem as this has been going on since I got the kit. Out of the box I plugged everything in to see if it was functioning before installing and it was doing that. I'll disable the fail-safe. Could you provide any detail as to why you want me to disable the fail-safe as a test? I did try a brand new gauge cable thinking perhaps a crimp was bad. Same problem.
Last edited by blk01s4; 28-07-2015 at 06:59 PM. Reason: * |
#4
|
|||
|
|||
![]()
The top yellow led is solely responsible for failsafe. I doubt failsafe is the cause.
Most likely to be a dry joint. Can you take a Hi-res picture and send it to Richard at aquamist.co.uk I like to examine a few surface mount components. If I see a suspect joint, can you solder? Just needs re-flowing.
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
![]()
Im assuming you want me to take a high res photo of the back of the dash gauge's circuit board? I can probably re-solder, however will this void the warranty?
|
#6
|
|||
|
|||
![]()
Yes, the back of the gauge circuit board. The bezel unscrews.
I will take care of the warranty for you. Provided oyu do drop a big blob of solder onto the circuit board.
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
![]()
No worries sir im pretty good with the ole soldering iron! I'll get the pictures tonight
|
#8
|
|||
|
|||
![]()
Still have not received the picture.
__________________
Richard L aquamist technical support |
#9
|
|||
|
|||
![]()
Hi Richard, haven't had a chance yet to take the vent out of my car. I'll be gone this weekend. should have the picture Monday.
|
#10
|
|||
|
|||
![]()
Hi Richard YGM!
|
![]() |
|
|